Heat Calculations | Chemical Recommendation Chart
1 and 3 Phase Amp Chart | 1 and 3 Phase Ohms Chart
Typical System Installation Diagram
Tank Size

In inches: width (left to right), length (front to back) and depth (top to bottom)

Tank Material

Polypropylene, polyethylene, steel with a PVC lining, stainless steel, titanium, etc.

Chemical Composition

If you're not sure, fax your MATERIAL SAFETY DATA SHEET to us at 805-483-1101.

Voltage

The voltage comes in 110-120, 208, 215, 220, 230, 240, 250, 430, 440, 460, 480, and 500 volts. It is best to have measured your voltage with a VOM METER to verify the exact voltage. Discrepancies in voltage can cause problems.
TITAN winds its 110-120 volt heaters at 125V, 208 volts at 220V, and 240 volt heater at 250V. The 480 volt heaters are wound at 500 volts. If your voltage exceeds these limits, the heater life will be greatly affected.

Phase

The heaters typically come in 1 and 3 phase. Contact an electrician and have them verify the phase and the voltage.

pH of the Solution

Operating Temperature Desired

Ambient Temperature

Heat-up Time Required